Garage floor concrete in Pleasant Hill CA - a solid floor that's ready for the car
Cracked, sinking or chipping garage slab? We pour a new one on a packed base, with joints planned so cracks go where we choose.
What goes into a new concrete garage floor in Pleasant Hill?
Garage floor concrete is the forming, pouring and finishing of the slab your car parks on, and in Pleasant Hill we replace worn, cracked or sunken garage floors with a new slab built on a packed base and reinforced to carry the load. Garage slabs sit at the thicker end of what goes into a house, since they carry cars and not just people.
Most calls start with a slab that's cracked across the middle, sunk at one corner or chipping where the tires sit, and by then the old floor usually comes out. The price moves with the size of the garage, how thick and how heavily reinforced the slab needs to be, and how much old concrete we break out and haul away first. The schedule turns on the weather on pour day, the cure afterward and the city's paperwork when a job needs a permit. Your own figure comes from the estimate, which I write after I've seen the garage.
What happens when you call about a garage floor in Pleasant Hill?
Call or send the form
Call (707) 750-8660 or use the form and tell us a little about the garage. We get back to you to set a time for me to come out.
I look and write the estimate
I check the slab, the ground around it and where the water goes, and ask how you use the garage, whether that's two cars or a workshop. You get a written estimate that shows how we'd reinforce and joint your floor, so you know the figure before you decide anything.
We plan around your house
We schedule the work around your cars, your driveway and your neighbors. The city allows construction from 7:30 a.m. to 7:00 p.m. on weekdays and 9:00 a.m. to 6:00 p.m. on weekends, so the truck and the crew arrive inside those hours.
Pour, finish and clean up
Our own crew does the work, and I'm usually there on pour day. When we're done we clean up and tell you when the floor is ready for the car.
How we pour garage floor concrete, and the work that goes with it
Concrete cracks, so we'd rather pick where. We break out the old floor and haul it off, then dig out the subgrade, the dirt and rock the slab sits on, and pack it firm instead of raking it level, because a lot of Contra Costa County soil swells when it's wet and shrinks when it dries, and a slab on loose fill rides right along with it. That county rating says nothing about your particular lot, so I look at the ground once it's open. We check where the water runs so the floor falls toward the door and not back toward the house, set rebar, the steel that holds the pieces together when the slab does crack, and pour early in the day so the top doesn't bake in the afternoon heat and turn weak and dusty. Then we cut the control joints, shallow grooves that give the cracks a straight line to follow, and tell you how long the curing takes, the slow hardening that sets the floor's strength. If you want a drier floor, ask whether a quote includes a vapor retarder, a layer under the slab that cuts the moisture rising from the ground. California stormwater guidance says concrete trucks wash out only at designated spots, never into the street or a storm drain, so you can ask us where ours will. When the budget gets tight, I'll cut almost anything before the base, because nobody sees it on day one and everybody sees it later.
A new garage floor often makes the concrete next to it look tired. If the walk to the side door or the patio off the garage needs more than plain gray, our decorative concrete adds texture, color or a stamped pattern. If the garage is cut into a slope and the dirt beside it keeps sliding toward the slab, concrete retaining walls hold that ground back. We do this work across Pleasant Hill and the cities around it.
Get a written estimate for your new garage floor
Send the form and we'll reply within one business day to set a time for me to come out and look at the garage. The estimate is free, done at your property, and comes with no obligation.
Garage floor questions from Pleasant Hill
How much does a new concrete garage floor cost in the Bay Area?
A new concrete slab in the Bay Area usually costs about $8 to $16 per square foot, and that's the going range for the slab across the area, not our price. The same guide puts reinforced slabs above un-reinforced pads per square foot, so reinforcement moves the total, and so do the garage's size and the old floor that has to come out. Your own figure comes from the estimate after I've seen the garage.
Will my new concrete garage floor crack?
It will probably get some cracking, because most concrete shrinks a little as it dries. Enough reinforcement and well-placed contraction joints, the planned lines where a slab is meant to crack, keep the large visible cracks under control, so ask each contractor you're comparing how they'll reinforce and joint your floor. Our promise is satisfaction guaranteed on every job.
How long before I can walk or drive on a new garage floor?
You should be able to walk on a new slab within 48 hours, and waiting a week before heavier loads is the safe course. Full curing takes about a month, so plan on keeping the heavy things off the floor for at least that first week. We'll tell you when it's ready for the car.
Who is allowed to pour a garage floor in California?
A contractor licensed in the concrete class by California's Contractors State License Board, which covers forming, pouring, finishing and installing flat concrete like a garage slab. The board only exempts minor work whose total price, labor and materials together, is under $500, and not when the job is part of a bigger project or split into hourly fees to stay under that line. We're licensed and fully insured.
Do I need a permit to replace a garage floor in Pleasant Hill?
The city decides that for your project, and it handles all building permits through its PHill Online Service Center, where you apply, upload plans, pay fees and schedule inspections. Its Online Permit Guide builds a custom list of steps for a home project based on its location and details. We'll tell you which office handles your address, and when a job needs a permit we take care of the paperwork for our part of the work.
What causes a new concrete floor to turn dusty or uneven?
Usually it's poor timing on the finishing, jointing and curing, which national concrete guides call critical to the surface you'll park on. Get that timing wrong and you can end up with cracking, dusting, flaking called scaling, high and low spots and water that won't drain, so ask any crew how they time those steps. Our own crew does the work, and I'm usually there on pour day to make those calls.
Other concrete work around the garage
Decorative concrete
If the walk or patio next to your garage looks worn beside a new floor, colored or patterned concrete can bring the outside up to match.
Concrete retaining walls
When the yard beside your driveway sits higher than the slab, a concrete wall holds the dirt back so it stops washing onto the floor.
Have your garage floor looked at first
Concrete is hard to undo, so the time to talk about the base and the joints is before the truck shows up, and if you call (707) 750-8660 or use the form, have the garage's size in square feet and your address ready.